Home / Guides
Goggles & gear

How to stop goggles fogging

By the Find My Swimming Pool team· Updated · 4 min read
Wellington Regional Aquatic Centre, Wellington
Wellington Regional Aquatic Centre, Wellington. A lane swimmer doing front crawl in the 50m pool in Wellington.

Four lengths in and you cannot see the wall. Foggy goggles are the most common complaint at any pool, and most of the time the cause is something you did to the lenses, not the goggles themselves. Here is why it happens and what works.

The short answer

Goggles fog because warm, moist air from your face condenses on lenses cooled by the pool water. New goggles have an anti-fog coating on the inside of the lenses. Keep it working by never touching or wiping the inside, rinsing in cool fresh water after each swim and drying them away from heat. When the coating wears off, use an anti-fog spray or a drop of diluted baby shampoo, rinsed lightly. Splashing the goggles with pool water before you put them on also helps.

Why goggles fog

Your face is warm and gives off moisture. The water around the goggles is cooler. Inside the small sealed space between your eye and the lens, the warm, damp air meets the cool lens and condenses into tiny droplets. That mist is the fog.

It is worse when the temperature gap is bigger: a cool outdoor pool, a hard swim that makes your face hot, or goggles that sat in a warm bag before you put them on. It is also worse when the lens surface is dirty or greasy, because droplets cling to it.

Indoor 50 metre pool with a red diving tower and large windows
Alsterschwimmhalle, Hamburg. The indoor 50m pool and diving tower at the Alsterschwimmhalle in Hamburg.

Look after the anti-fog coating

Most goggles come with a thin anti-fog coating on the inside of each lens. It makes condensation spread into an even, clear film instead of droplets. It is also easy to destroy.

  • Never touch the inside of the lenses. Fingers leave grease and scratch the coating.
  • Never wipe or rub them. Not with your towel, your T-shirt or your thumb. Let water drain off instead.
  • Rinse after every swim. Cool fresh water, inside and out, to wash off chlorine.
  • Air dry. Leave them to dry in the open, then store them in a case. Keep them out of direct sun and off radiators.
  • Do not leave them in a hot car. Heat damages the coating and the seals.

Looked after this way, the coating on a decent pair of goggles lasts for months of regular swimming.

Wet them before you put them on. Dip your goggles in the pool, empty them and put them on with the inside still wet. A wet lens starts closer to the water temperature and fogs less in the first few lengths.

Quick fixes at the pool

  1. Rinse and reset. At the wall, take them off, dip them in the pool, shake out the water and put them back on. This clears the fog for a while.
  2. Cool down your face. Splash pool water on your face before you put the goggles on.
  3. Check the fit. Goggles that leak a little let in pool water, which then evaporates and fogs the lens. Tighten the strap or adjust the nose bridge.
  4. Spit, if you must. Many swimmers rub a little saliva on the inside of the lens and rinse it. It works for a short while, but rubbing damages any coating that is left, so keep it for old goggles.

Fixes for old goggles

Once the factory coating has gone, the lenses will fog every time unless you add something. These are the common options:

MethodHowHow long it lasts
Anti-fog spray or dropsApply to dry lenses, spread with a fingertip, rinse lightlyOne session, sometimes more
Diluted baby shampooA drop mixed with water, spread inside, rinse lightlyOne session
SalivaSpread inside, rinseA few lengths
Anti-fog wipesWipe inside, let dryOne session

With any of these, use them only on goggles whose coating is already gone, and rinse with a light touch. Too much product leaves a blur, too little rinsing makes your eyes sting.

What not to do

  • Toothpaste. Often suggested online. It is mildly abrasive and scratches the lens.
  • Washing-up liquid. Works as an anti-fog film but stings badly if any is left.
  • Household glass cleaner. Not made to go near your eyes.
  • Hot water. It can warp the frame and damage the seals.

When to buy new goggles

If the lenses are scratched, the seals have gone hard or sticky, or the strap is cracked, replace them. Fog is easier to live with than leaks. When you buy, look for goggles that say they have a durable or long-lasting anti-fog coating, and treat it gently from the first swim.

A pair that seals well also fogs less, because no pool water gets inside. Our guide to why wear goggles explains how to check the fit. For keeping the rest of your kit in good shape, see how to wash a swimsuit.

FAQ

Why do my new goggles fog up?

Usually because the inside of the lenses has been touched or wiped, which damages the anti-fog coating. Warm goggles in a cool pool also fog more.

Does baby shampoo stop goggles fogging?

Yes, a drop mixed with water and spread on the inside of the lenses works for a session. Rinse lightly so it does not sting.

Can I restore the anti-fog coating?

Not the original one. You can use an anti-fog spray or drops before each swim instead.

Do mirrored goggles fog less?

Not really. The mirror is on the outside. Fogging depends on the inside coating and the fit.